|Home||» Products||» Industrial Blower||» Medium Pressure Twin Lobe Pumps|
Medium Pressure Twin Lobe Pumps
Medium Pressure Twin Lobe Pumps
Under the instructions and directions of our team of well-experienced professionals, the Turbo twin lobe rotary is manufactured in two models twin lobe, to provide positive displacement compressors. By using the innovative tools & techniques, modern machinery and superior quality components, these twin lobes are designed. Our quality experts strictly examined and controlled all the smallest details of production. The range of twin lobe compressors in capacity up to 50, 000 m3hr, is maintained by factory trained personnel to provide reliable field services. Further, the twine lobe model has three impellers, in each shaft rotating in opposite direction and the rotary positive displacement compressor twin lobe model has two figures, eight impellers rotating in opposite directions
Approximately, one-fourth of the quantity of air is trapped while the displacement of the compressor, Medium Pressure Twin Lobe Pumps of an impeller passes the compressor inlet. Moving the entrained air around the case to the compressor outlet, this entrapment occurs four times per revolution. In relation to each other, the Ground helical timing gears accurately position the impellers and to maintain the minute clearances of the rotary positive compressor, so vital to the high volumetric efficiency. Back to the suction side of the compressor, a slight amount of air escapes past the operating clearances because the compressor operates with very close internal tolerances. For any given compressor, this leakage, defined as 'slip' is a predictable constant volume at any given pressure.
This leakage is expressed in compressor rpm., for ease in calculation. For each compressor size a standard slip has been established, based on handling air at standard condition. When calculating total operating speed of the unit, the slip will vary and must be taken into consideration for gases having a specific gravity other than 1.0. To give highest volumetric efficiency, this twin lobe compressor is built with the closest possible tolerances. As our company is a reliable Supplier, Manufacturer and Exporter of Twin Lobe Rotary Blower, based in India. We make sure every twin lobe compressor is tested before shipment to provide the defect free products.
- 100% oil free air
- Generously sized bearing to handle dynamic load
- Rotary oil sealing
- Alloy steel hardened and ground timing gears for better life
- Rigid one piece graded cast iron casing for vibration free operation
- Easy rotor timing setting through taper mount procedure
- Improved, efficient rotor design and precision synchronization for lesser slip and higher volumetric efficiency
- Alloy steel shaft ground to close tolerances for better fitment
- Simple, easy and low cost maintenance
- Better volumetric efficiency results in low operation cost.
Industrial: Steam compression, oil free handling of industrial gases, Non combustion process heating, Pulp and paper processing, Fluid bed combustion
Pneumatic Conveying: Pressure conveying of heat sensitive material, Fluidization and agitation of dense powders and liquids
Food processing: Conveying grains, Dehydration, Vacuum packing etc.
Chemical/Gas processing: Handing corrosive gases, non sparking applications, distillation of vapour gas.
Environmental: Soil vapor extraction, Air sparging, Compost aeration, smoke stack filtration, dust collection, gas disposal, mobile vacuum waster water treatment, effluent water treatment, sand filter backwash, Sludge conditioning, Digesfer gas processing.
- Contact Details
- TURBO BLOWER MANUFACTURER
- Gala No. 2, Behind Amin Compound, Sonawala Cross Road No. 2, Goregaon (E), Mumbai - 400063, Maharashtra, India
- Mr. Himanshu Yadav (Proprietor)
TURBO BLOWER MANUFACTURER All Rights Reserved.